Turbulence D3 Tail Holder Mount for HIROBO HI0414487  [HI0414487]

Turbulence D3 tail-holder overview

This is an RC-scale tail holder designed for the Hirobo Turbulence D3 series, intended to secure the tail output linkage and support consistent tail shaft alignment. The part concentrates on the mechanical interface between the tail gearbox output and the tail linkage, helping preserve repeatable geometry during setup and routine maintenance.

Installation is simple for builders experienced with helicopter tail assemblies: remove the original tail holder, position this holder to align the tail shaft and linkage, and fasten using the model's existing mounting points and fasteners. Check alignment and any free play before test flights, and retighten hardware to the model's recommended torque values.

When used during maintenance this holder offers a stable mounting surface that reduces unwanted flex at the tail output, aiding more predictable tail control response and making adjustments to tail pitch and tracking easier during setup.

Use this replacement part when restoring or upgrading the tail mounting interface on Turbulence D3 airframes to regain correct tail geometry and simplify tuning.