Turbulence D3 SSZ-IV Stabilizer Control Arm HI0414463 by Hirobo  [HI0414463]

Replacement stabilizer arm for Turbulence D3 SSZ-IV

This is an RC-scale stabilizer control arm from Hirobo, listed under model HI0414463 and intended for use on the Turbulence D3 SSZ-IV helicopter tail assembly. Use this part as a direct replacement when the existing stabilizer link shows wear or damage, or when you need a spare part for field repairs.

Installation and fit are intended to match the original mounting points on the Turbulence D3 SSZ-IV tail framework, check existing linkage alignment and ball-bearing seating before flight. The arm serves a tuning role in the tail stabilizer linkage by maintaining geometry between the tail rotor controls and the stabilizer assembly, so confirm free movement and correct servo centring after replacement.

When swapping the control arm, inspect associated fasteners and link pins for wear, and verify that any retained bushings or spacers are reinstalled in their original order. This part is an RC helicopter replacement accessory and is not for any full-scale or non-RC application.