TT-01 Rear Camber Arm Set - TAMIYA TT01-21 by 3Racing  [TT01-21]

Rear camber lower arm for TT-01 platforms

This rear camber suspension arm set is built for TAMIYA TT-01 and TT-01 TYPE E chassis and is supplied under 3Racing part number TT01-21. It replaces the rear lower arms and provides the correct mounting interface to manage rear camber geometry and wheel alignment on the chassis.

The arms restore the factory mounting locations for the rear uprights and associated linkages, making it straightforward to set camber during regular setup or after component replacement. Use this set when the original rear arms are worn, cracked, or removed during maintenance.

Installation notes and tuning role:

• Fit and alignment: test fit the arms against TT-01 rear uprights and, where possible, reuse the original mounting hardware; confirm free pivoting before fully tightening fasteners.
• Routine checks: after fitting, check pivot points for looseness and re-check wheel camber with your preferred gauge to ensure repeatable handling.
• Tuning role: these arms keep the stock mounting geometry so camber changes are made through link length and upright shims rather than altering the arm itself.