TRX4M Front CVD & Rear Axle Shaft Kit TRX4M032S by GPM  [TRX4M032S]

Front CVD and rear axle replacements for TRX4M

This replacement set covers the front constant velocity drives and rear axle shafts fitted to TRX4M Ford Bronco 1/18 scale kits. Made from medium carbon steel, the components aim to restore drivetrain function and serve as durable spares during regular maintenance and setup checks on TRX4M models.

The kit transfers wheel rotation through the front CVD area and rear axle assemblies, providing a direct swap for worn or damaged stock pieces. Supplied as a service kit with front CVD pieces and rear axle shafts, these parts are intended to fit most standard TRX4M configurations without extra machining.

Installation notes: remove the front and rear driveline housings for access and use common RC tools such as hex drivers and pliers. Check spline engagement and mating surfaces during assembly, then hand-spin the driveline slowly to confirm free rotation and correct alignment before powering up.

Tuning and use: these medium carbon steel shafts are chosen for dimensional stability under typical trail and crawling loads for 1/18 TRX4M rigs, and are a logical replacement when composite OEM parts show fatigue or wear.

This GPM kit supplies medium carbon steel front CVDs and rear axle shafts as direct replacement components for the listed TRX4M platforms, suited to routine drivetrain servicing on 1/18 crawlers.