TRX-4 Ford Bronco Front Bumper Mount TRX4330FF, D-ring Ready by GPM  [TRX4330FF]

6061 T6 aluminium front bumper mount for TRX-4 Ford Bronco

This aluminium front bumper mount and D-ring kit is a scale-focused upgrade made for the TRAXXAS TRX-4 Ford Bronco chassis. The part installs at the front bumper area to provide a reliable anchor for recovery gear and a reinforced mating surface that pairs with the stock bumper mounts.

Constructed from aluminium 6061 T6, the component balances reduced mass with good tensile strength for trail and scale driving. The CNC-inspired profile and smooth finish help the part resist bending under typical RC loads while keeping an authentic scale look.

In practical use the mount secures D-rings for towing or recovery, reduces flex at the front bumper attachment when under load, and creates a repeatable mounting datum for swapping aftermarket bumpers. Installation uses the supplied hardware and is designed to fit in the front bumper location without modifying the main chassis on compatible TRX-4 Ford Bronco bumpers.

For builders tuning TRX-4 Ford Bronco scale rigs, this aluminium bumper mount gives a solid D-ring anchor and reduces front-end flex when using a winch or towing; use the included M4 pins for a straight swap of the factory bumper bracket.