TRF104 Graphite Rear Wing Mount 2.0 - TAMIYA O-TCPF07  [FP-O-TCPF07]

Price:
CAD$14.75
Brand:
Factory Pro
Model:
FP-O-TCPF07
Condition:
Brand New
Write a review

TRF104 Wing Mount Upgrade

The Factory Pro O-TCPF07 rear wing mount is made to fit the TAMIYA TRF104 chassis as a direct replacement or performance upgrade. Manufactured in a graphite 2.0 material, it increases stiffness at the wing mount compared with standard plastic pieces while keeping the overall weight low.

Fitment is intended specifically for TRF104 layouts; the part uses the same mounting footprint as the original so that typical kits will accept it without chassis alteration. Confirm the location of your wing posts and fasteners before installation to ensure a correct fit.

Installation is a straightforward bolt-in swap for an experienced builder: remove the factory mount, align the Factory Pro unit with the TRF104 wing posts, and refit the original screws. After tightening, check wing symmetry, clearance and that the mount does not contact nearby bodywork during suspension travel.

Tuning effect: the added stiffness from the graphite 2.0 mount reduces unwanted movement at the wing root, helping the wing keep its set angle under aerodynamic load. That stability makes wing adjustments more repeatable when dialing rear grip and balance.

It is designed around the stock TRF104 wing post layout, but many modified touring builds with unchanged post positions will accept it. Always check alignment before final fitting.
The O-TCPF07 is intended to use the TRF104's existing hardware in normal setups; inspect your screws for wear or length differences and replace only if they do not seat properly.
Graphite raises stiffness at the mount which can change crash behaviour; it reduces flex but may transfer more force into the wing or supports. Check for stress after impacts and consider reinforcement if you run aggressive setups.

Copyright © 2008-2026 rcjaz.ca All rights reserved