TRF104 Front Stiffener Graphite 2.0 - Tamiya Factory Pro O-TCPF03  [FP-O-TCPF03]

Price:
CAD$11.52
Brand:
Factory Pro
Model:
FP-O-TCPF03
Condition:
Brand New
Write a review

TRF104 graphite front brace

This Factory Pro FP-O-TCPF03 front stiffener is an upgrade piece designed for the Tamiya TRF104 chassis and is supplied as one matching pair. The component is made in a graphite 2.0 form and is intended to alter front-end rigidity for setup tuning.

On the track the stiffener raises front-section stiffness to change steering response and balance. It is used alongside spring and damper adjustments to refine understeer or oversteer without replacing major drivetrain parts.

Fitting is straightforward for hobbyists: the stiffener mounts to the TRF104 front assembly using the chassis original mounting points. Retain factory fasteners and follow standard service practice when removing and refitting front components. Basic hand tools for Tamiya models are sufficient.

Tuning advice: expect a firmer front sensation; confirm handling on short test runs and tweak spring rates, anti-roll bars and tyre choices as needed. Make incremental changes and record each setup to compare lap-to-lap behaviour.

Compatibility

  • Tamiya TRF104 chassis

How does the graphite stiffener change steering?

It increases front rigidity so the car turns with a firmer initial bite, which can tighten corner entry when combined with matching suspension settings.

Will I need new screws to fit it?

No extra fasteners are usually required; install into the existing TRF104 front mounting holes and reuse the original hardware unless damaged.

When should I remove the stiffener during setup?

If the car becomes too nose-heavy or snaps into understeer, remove or soften the front setup and revisit spring and tyre choices rather than keeping the stiffener fitted permanently.

Copyright © 2008-2026 rcjaz.ca All rights reserved