Traxxas XO-1 Aluminium Front Arm Bulk XO008 by GPM  [XO008]

Front arm bulk in aluminium for XO-1

This aluminium front arm bulk is a single-piece replacement made for the Traxxas XO-1 scale chassis and is supplied as one unit. The component replaces the stock front arm bulk and is offered as an aftermarket replacement under model XO008.

Fitment is specific to the XO-1 front bulk layout stated here; confirm your chassis geometry before ordering. The listing does not guarantee inclusion of mounting hardware or bearings unless your seller states otherwise.

Installation notes: remove the original front arm bulk following your vehicle's teardown sequence, move any bearings or retainers you intend to reuse, align the new bulk to the steering assembly, and secure it using the original fasteners to the manufacturer's torque recommendations. After fitting, verify steering range and suspension travel and correct toe or camber if needed.

Tuning role: as an aluminium front arm bulk the part increases front-end stiffness and alters steering feedback. Using a denser material typically reduces flex under load and gives a more linear steering response, which helps when fine tuning front suspension for on-road speed setups. Expect changes in steering feel rather than dramatic speed gains.