TRAXXAS Xo-1 0mm Aluminium Wheel Hex Claw XO006 by GPM  [XO006]

0mm aluminium hex claw for Xo-1 wheels

The XO006 aluminium wheel hex claw is a precision replacement part made to mate with TRAXXAS Xo-1 wheel hubs. Supplied as a pair, these machined aluminium claws preserve a 0mm offset and act as a direct-fit solution for secure wheel mounting and alignment on Xo-1 assemblies.

Installation is straightforward for hobbyists used to hub work: remove the wheel and original hex, inspect hub seating and bearings, then install the aluminium hex claw using the original hardware orientation. Apply correct hex screw torque and verify wheel runout after fitting to prevent misalignment.

As a service and tuning component this part replaces worn hexes and provides a stable mounting interface. The aluminium construction keeps consistent geometry for checking toe, camber, and wheel balance during setup or after impact repairs.

This XO006 hex claw is intended for RC wheel mounting on TRAXXAS Xo-1 chassis where a 0mm offset aluminium hex is required; use standard hub hardware and confirm fitment before running.