TRAXXAS X-MAXX Upper Support and Adjustable Upper Arms TXMW054FRS by GPM  [TXMW054FRS]

Adjustable upper supports for X-MAXX

This supporting mount kit replaces the front and rear upper arm assemblies for TRAXXAS X-MAXX and is built as an aftermarket hop-up for hobbyists. The design pairs stainless steel pins with lightweight aluminum mounts to increase structural stiffness while keeping added weight to a minimum, letting drivers tune suspension length and wheel angle for different surfaces.

The arms are adjustable: loosen the mounting screws, insert a pin or an Allen key into the adjuster, then rotate to lengthen or shorten the link. That simple action changes suspension geometry and wheel toe/camber tendencies, so you can dial in small setup changes without swapping fixed-length links. Parts are suitable for the upper arm positions noted in the compatibility listing.

Installation notes: the set fits the MAXX models listed in the compatibility box below, uses the supplied stainless steel pins and flat head screws for secure mounting, and requires standard RC hand tools. Verify fit on your chassis before final assembly and torque stainless fasteners carefully to avoid thread damage in the aluminum mounts.

As an aftermarket support set for TRAXXAS X-MAXX, this stainless steel and aluminum upper arm kit gives a practical way to tune suspension geometry for varied track conditions while controlling weight and improving part stiffness.