TRAXXAS X-MAXX Rear Wheel Hex Claw +3mm with Brake Disk TXM006R/DISK by GPM  [TXM006R/DISK]

Machined aluminium rear hex for X-MAXX

This machined aluminium rear wheel hex claw with an integrated brake-disk face is an aftermarket upgrade for TRAXXAS X-MAXX owners looking for a stiffer, lower-profile wheel mount. The part gives a permanent +3mm offset and a precise mating surface to help maintain wheel and tyre alignment under high torque and larger motor setups common in big-scale RC running.

The alloy construction reduces seat flex compared with standard plastic hexes, improving repeatability when you swap tyres or push power levels. The brake-disk face is provided as a locating and mounting surface only and will not change how your vehicle's braking hardware operates.

Installation notes: this item fits directly into TRAXXAS X-MAXX rear hubs and uses the same retention method as factory hexes. Use the recommended hex screw size and correct torque to avoid damaging wheel studs, and verify wheel runout after fitting. As a machined metal component, inspect the contact faces and threads periodically and apply thread locker where the drivetrain manual advises it.

For hobbyists tuning rear-end stability on X-MAXX rigs, this aluminium hex claw gives a firmer wheel mounting with a +3mm offset to fine-tune stance and reduce unwanted movement without modifying hub geometry.