TRAXXAS X-MAXX Aluminum Servo Mount, Tie Rod & 25T Servo Horn TXM024N by GPM  [TXM024N]

Machined 6061-T6 servo mount for X-MAXX

This GPM TXM024N kit adapts the servo mounting and linkage on TRAXXAS X-MAXX platforms to accept larger servos that share the 2075x footprint. The package replaces stamped or plastic components with machined 6061-T6 aluminum parts to increase mounting rigidity and keep alignment under sustained steering load.

The original package includes the servo mount, one aluminum tie rod, a 25T aluminum servo horn, a selection of stainless steel screws in multiple lengths, and small shims to fine-tune fit and preload. These items allow direct replacement of stock mount points when the new servo matches the bolt pattern and dimensions of a 2075x style unit.

Installation notes: check your servo case dimensions and horn spline alignment before fitting, keep correct horn indexing and centering shims, and torque cap-head screws to a level suitable for aluminum-to-aluminum contact to reduce the chance of thread damage. Because the aluminum mount is stiffer than plastic, recheck steering endpoints and trim after installation and during early test runs.

Tuning role: fit this kit when you want a firmer steering response and less flex between servo and linkage, especially when moving to a higher-torque metal-geared servo on 8S setups where precision matters. Expect steadier steering geometry under repeated loads, which helps with predictable handling during setup.

The TXM024N set is a simple aluminum upgrade for TRAXXAS X-MAXX owners who need a stronger servo mounting solution for larger servos, with hardware included to cover common mounting details.