Traxxas X-MAXX #45 Steel Dogbone Set 3pcs TXM1160S/1 by GPM  [TXM1160S/1]

TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1
Price:
CAD$17.93
Brand:
GPM
Model:
TXM1160S/1
GTIN:
4894538281705
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1" title="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1"
alt="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1" title="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1"
alt="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1" title="TRAXXAS X-MAXX Steel #45 Dogbone-3pc set - GPM TXM1160S/1"

#45 Steel Dogbones for Traxxas X-MAXX

This aftermarket RC dogbone set fits TRAXXAS X-MAXX platforms and is listed as TXM1160S/1. The components are made from steel #45 to provide a stiffer driveshaft choice versus stock-diameter dogbones.

Reported dimensions: the shaft section steps up from 5.5mm to 7mm to resist bending under heavy loads, and the end pins are given as 3.5mm diameter. The supplied small parts include 1 pcs 3.5-thread steel collar and 1 pcs 3.0x20 steel pin with the 3pcs dogbone set.

Fitting and setup tips: these steel dogbones suit rough off-road and rally-style running where a thicker shaft reduces deformation and helps stabilise the drivetrain. Verify hub and axle bore clearances on your X-MAXX before fitting, confirm the 3.5mm pin fit, and recheck retention hardware after a short break-in run to avoid interference with suspension travel or bearings.

Compatible Models

  • Traxxas Xmaxx 6S

Will these dogbones fit a standard X-MAXX axle?

Measure your hub and axle bores first; the set is made for Traxxas Xmaxx 6S style hubs and uses a 3.5mm pin, so check those dimensions before installation.

Should I lubricate the dogbone shaft?

Light lubrication on mating surfaces helps reduce wear during the initial break-in, but avoid excess grease that can attract grit when running off-road.

Any quick installation checks recommended?

After installing, confirm free suspension travel and spin the wheels to check bearings and hubs for binding; re-tighten retention hardware after a brief test run.

Copyright © 2008-2026 rcjaz.ca All rights reserved