TRAXXAS X-MAXX #45 CVD and Wheel Shaft Upgrade TXM812160S by GPM  [TXM812160S]

Reinforced #45 CVD set for X-MAXX

This four piece replacement set supplies hardened steel #45 constant velocity drives and wheel shafts sized for TRAXXAS X-MAXX applications. The components are intended as an aftermarket drivetrain upgrade where stock CVDs wear quickly under 6s or 8s power. The focus is on sturdier geometry and material hardness to sustain torque without cosmetic alteration.

Design changes include a body wall increased by 1.5mm and a shaft pin thicker by 0.5mm, plus a larger outer diameter on the inner wheel joint versus the original parts. The finishes are modern black and the hardened steel construction reduces shaft bending and premature failure when running higher-output batteries and motors.

Installation is a direct swap of the joint bodies and wheel shafts for either front or rear positions; expect standard hub and CVD retainer removal. When upgrading a vehicle to 6s or 8s, this kit works as a tuning-stage replacement to lower drivetrain upkeep and keep power transfer consistent under load.

Choose this set to replace fatigued stock CVDs or to strengthen the drivetrain when pushing a TRAXXAS X-MAXX with higher-voltage systems.