TRAXXAS X-Maxx 1/8 18T Steel Motor Pinion TXM018TS by GPM  [TXM018TS]

TRAXXAS 1/8 X-Maxx Steel Motor Gear (18T) - 1pc - GPM TXM018TS
Price:
CAD$15.32
Brand:
GPM
Model:
TXM018TS
GTIN:
4894538190069
Condition:
Brand New
Write a review

18T steel pinion for X-Maxx

This aftermarket 18T steel motor gear is made for the TRAXXAS 1/8 X-Maxx and sold as a single piece. It serves as a direct replacement pinion to restore or change the motor-to-geartrain mesh using its 18-tooth profile and hardened steel construction.

Fit this pinion when replacing a worn or damaged motor gear or when altering gear ratios for setup and tuning. Steel construction keeps tooth geometry stable under load, helping maintain consistent mesh in high-torque configurations.

Installation notes: remove the motor from its mount to swap the pinion, set correct mesh and backlash against the spur gear, and re-check set-screw tightness after initial running. Regular inspections for tooth wear and secure set-screw seating are recommended.

This item is compatible with

  • TRAXXAS XMAXX
  • TRAXXAS XO 01

What is included with the pinion?

One steel motor gear, sold as 1 pcs.

Can I fit this to other Traxxas kits?

This part is listed for the TRAXXAS 1/8 X-Maxx; confirm pinion bore size and motor shaft type before attempting fitment on other models.

How should I set up the gear mesh?

Start with minimal backlash, rotate the gears to seat the teeth, tighten the set-screw, then re-check mesh after a short test run to ensure no binding.

Copyright © 2008-2026 rcjaz.ca All rights reserved