TRX-4 Front Bumper Ballast Mount TRX4331FXA by GPM  [TRX4331FXA]

Brass front bumper mount for TRX-4 crawlers

This brass front bumper mount is a scaled RC accessory intended to stabilise the front bumper and add forward ballast on Traxxas TRX-4 based trail crawlers. The part helps lock bumper alignment for a firmer chassis interface, and provides an external counterweight (approx. 200g) useful when adjusting front-end balance for crawling or technical trail driving.

The kit contains the brass mount plus the steel hardware needed for a straightforward fitment. Typical installation locates the mount on the vehicle's front bumper assembly using the supplied screws and washers, and in many setups the component allows the servo to be shifted forward slightly to alter the front centre of gravity. Use this piece as part of step-by-step tuning rather than as a replacement for proper chassis setup.

• Includes: Brass bumper mount - 1pc
• Includes: Stainless steel flat head screw 3x12 - 4pcs
• Includes: Stainless steel round head screw 3x8 - 4pcs
• Includes: Alloy counter sink washer 3mm - 4pcs
• Includes: M4x2.5x14.5 screw shaft - 2pcs

A purpose-built brass upgrade for TRX-4 scale models that helps steady the front end and enables measured ballast tuning during trail crawling setups.