TRAXXAS TRX4 Scale Bumper D-rings 4pc Set TRX4003 by GPM  [TRX4003]

Aluminum bumper D-rings for TRX4

This accessory is made for the TRAXXAS TRX4 Trail Crawler platform and is supplied as a 4-piece set of front and rear D-rings forged from aluminum 6061 T6. The rings give authentic-looking anchor points for scale recovery gear and enhance visual realism without suggesting any real vehicle application.

The kit includes screw pins to lock each D-ring in place, referenced in the source as Screw Pin-2PCS. Fitting is simple on TRX4 bumpers that accept D-ring mounts: align the D-ring with the bumper hole, insert the supplied screw pin, then tighten to a sensible torque. Use a suitable hex driver and check for interference with steering or suspension components after installation.

These D-rings are intended as scale recovery points and styling elements rather than load-bearing recovery hardware. They provide tidy mounting spots for lightweight tow rigs or scale accessories while keeping added mass low. As with any metal accessory, ensure correct thread engagement and avoid over-tightening to protect bumper mounting points.