TRAXXAS TRX4 Front Dogbone Set for Front CVD #45 Steel TRX44571/SH by GPM  [TRX44571/SH]

TRX4 front dogbone kit for CVD axles

This aftermarket 4 piece dogbone set is made to fit the TRAXXAS TRX4 Trail Crawler front CVD assembly and uses hardened #45 steel for improved wear resistance. The geometry matches stock dimensions so the dogbones install as a direct replacement without machining.

The dogbones transfer rotational torque from the front CVD into the axle shafts, acting as the drivetrain link between the transfer case output and the wheel hubs. Two 11.8mm stainless steel pins are supplied to retain the dogbones during operation.

Measure to verify fit: long leg is 71mm and short leg is 45mm. Use these lengths to check steering and suspension clearance before you fit the new parts.

Fitment notes: these components are intended for front CVD installations on TRX4 chassis that accept the same dogbone geometry. Standard replacement involves removing the original dogbones and installing the supplied set with the retention pins. No further modification is required.