Traxxas TRX-4 Front and Rear Bumper Mount Protector JR-TRX442 by JAZRIDER  [JR-TRX442]

Traxxas TRX-4 Stainless Steel Front/Rear Chassis Bumper Mount Protector Guard Ver.2 (1pc)
Price:
CAD$10.12
Brand:
JAZRIDER
Model:
JR-TRX442
Condition:
Brand New
Available in shop
Write a review

Mount protection for TRX-4 chassis

This stainless steel protector is a scale accessory designed to strengthen the front and rear bumper mount area on the Traxxas TRX-4 chassis. It provides a local metal guard around the bumper mounting points to reduce direct wear on the chassis surface during scale crawling and trail use.

Fit and design: made specifically for the Traxxas TRX-4 chassis, the plate follows the bumper mount zone and is formed to match existing mounting locations. Check your TRX-4 variant and bumper arrangement before installation to confirm clearance with aftermarket bumpers or other accessories.

Installation notes: the guard installs at the chassis bumper mount and acts as a sacrificial reinforcement where drivers want extra rigidity. It helps keep chassis attachment geometry intact when fitting heavier scale bumpers or when navigating contacts on technical trails.

How do I confirm fit for my TRX-4 variant?

Measure your chassis bumper mount spacing and compare with the mount pattern. This protector is shaped for TRX-4 mounting points; verify your variant and bumper layout before purchase to ensure correct fit.

Will I need extra fasteners to fit it?

Most installations use the chassis' original screws. If you require longer or replacement fasteners, pick hardware that matches the thread and clamp requirements of the mount points.

Does this alter bumper clearance or appearance?

The stainless plate is visible at the bumper mount area and can change clearance with some aftermarket bumpers. Always trial-fit your chosen bumper and check for interference before final assembly.

Copyright © 2008-2026 rcjaz.ca All rights reserved