TRAXXAS TRX4 FORD BRONCO Adjustable Stainless Upper and Lower Links STRX4160F by GPM  [STRX4160F]

Adjustable stainless suspension links for TRX4

This 20pcs stainless steel link kit is an aftermarket replacement set produced by GPM for TRAXXAS TRX4 FORD BRONCO platforms, intended to swap in for the stock upper and lower suspension links and give fine, user-adjustable length control. The links use a thicker tie rod body compared with the original parts to help resist wear and cut down on corrosion over time.

Length adjustment is done through the tie rod center hole by inserting a suitable tool and turning according to the counter-clockwise thread direction noted by the manufacturer. This lets you make small geometry changes without major strip-down, handy when dialing roll behaviour or axle alignment for trail running or scale crawling setups.

Fitting follows normal link replacement steps: remove the factory link fasteners, mount the new stainless links to the same points, and secure with the supplied stainless round head screws. After installation, cycle the suspension through full travel and confirm clearances and equal link lengths on both sides before final torque.

For builders who want a straightforward stainless upgrade, this GPM 20-piece set supplies the hardware and simple adjustment method needed to improve link longevity and let you tune suspension geometry on TRX4 Ford Bronco style rigs.