TRAXXAS TRX-4 Defender Rear Diamond Plate Bumper - JR-TRX433 by Jazrider  [JR-TRX433]

Traxxas TRX4 Defender Rear Bumper Stainless Steel Diamond Plate Slip Proof Tread
Price:
CAD$9.98
Brand:
JAZRIDER
Model:
JR-TRX433
Condition:
Brand New
Available in shop
Write a review

Scale rear bumper compatible with TRX-4 Defender

This RC-scale rear bumper is made for the Traxxas TRX-4 Defender chassis and is supplied under model JR-TRX433. The plate uses stainless steel diamond tread to deliver a textured, slip-resistant surface suited to scale trail access and rear loading tasks.

The part is supplied as a single replacement bumper intended for the TRX-4 Defender rear mounting location. Check your vehicle's existing bumper holes and fasteners to confirm fitment and whether any additional screws or spacers are required for installation.

When fitted, the bumper increases scale realism and gives a non-slip rear platform. It does not modify drivetrain, suspension, or electronics, though it can alter rear overhang mass slightly; verify balance after mounting to suit your setup.

How can I verify this fits my TRX-4 Defender variant?

Measure your current bumper mounting points against the replacement and compare hole spacing; the listing is for the TRX-4 Defender, so confirm the rear bracket locations on your specific TRX-4 variant before purchase.

Is the tread material stainless steel?

Yes, the bumper uses a stainless steel diamond plate tread designed to improve grip on the rear platform while resisting corrosion better than plain steel in typical trail use.

Will I need extra fasteners to mount it?

Inspect your model's existing bumper screws and hole sizes; you may need replacement or longer screws depending on body thickness or if spacers are added during fitting.

Copyright © 2008-2026 rcjaz.ca All rights reserved