Traxxas TRX-4 Defender Decorative Metal Plate TRX4ZSP44 by GPM  [TRX4ZSP44]

Scale metal plate for TRX-4 Defender

This TRX4ZSP44 metal trim is an RC-scale decorative plate intended for cosmetic use on Traxxas TRX-4 Defender models. It functions as an exterior decoration to refine scale appearance without affecting drivetrain or suspension components.

The part is supplied with adhesive so it can be surface-mounted to the Defender body panels. Placement is typically on the body sill, bumper facings, or other flat surfaces where a thin metal accent is desired. Installation requires only surface preparation and careful alignment; allow the adhesive to cure before subjecting the model to rough terrain.

From a setup perspective this component is for visual tuning only. It adds minor mass at the mounting point and should be positioned to avoid interfering with wheel travel, steering linkages, antenna mounts, or any moving parts such as servo arms, ESC cables, or motor leads.

Maintenance is minimal: clean mounting surfaces, check adhesive condition periodically, and remove if the plate shows deformation or damage after impact. Do not attempt to weld, bend excessively, or use this part on full-scale vehicles; it is designed for RC models only.