Traxxas TRX-4 / Axial SCX10 II Front Bumper with LEDs and D-Rings - JR-TRX443 by Jazrider  [JR-TRX443]

Heavy-duty aluminum bumper for trail crawlers

This RC-scale front bumper fits Traxxas TRX-4 and Axial SCX10 II chassis, constructed from aluminum and supplied with integrated LED lights and recovery D-Rings. It provides front-end protection for trail use while offering secure mounting points for lighting and scale recovery gear.

Compatibility is limited to the listed platforms: Traxxas TRX-4 and Axial SCX10 II. The bumper mounts to the vehicle's existing front mounting points and replaces or supplements the stock bumper; verify your chassis mounting pattern before starting installation. Standard hobby hand tools are sufficient for the light bracket work involved.

Installation notes: remove the factory bumper, align this assembly with the chassis mount holes, secure using the supplied or equivalent hardware, and route the LED leads to an appropriate power source such as a switched light circuit, accessory output on your ESC, or a small separate battery. Check LED polarity before finalising the wiring and keep cables clear of steering and suspension travel. The D-Rings are intended for scale recovery use only and should not be used for towing full-size loads.

Tuning impact: the bumper adds frontal mass and a solid platform for lights and accessories, which can alter approach angle and slightly shift front-end weight distribution; if you notice a change in ride height or handling during precise crawls, try small suspension preload or shock adjustments to compensate.

Select this aluminum front bumper when you need a durable scale accessory that combines frontal protection, integrated lighting, and recovery points for TRX-4 and SCX10 II based rigs, with straightforward installation and predictable tuning adjustments.