TRAXXAS TRX4 Adjustable Stainless Upper and Lower Links STRX4160 by GPM  [STRX4160]

Stainless adjustable suspension links for TRX4

This 20pcs stainless steel adjustable link set is made for RC TRAXXAS TRX4 Trail Crawler models and supplies replacement upper and lower suspension links to tune steering geometry and take up length play. The kit fits like-for-like with factory mount points, uses thicker tie rods than stock and employs a counter-clockwise thread so you can alter length without stripping the assembly.

The pack contains the tie rods plus a selection of stainless steel round head screws in lengths that correspond to the stock mounting positions, arranged for a straightforward swap-in of the original plastic links. To change a link length, insert a thin driver into the tie rod centre hole and rotate to extend or shorten until the alignment and steering response suit your setup.

Midpoint lengths measured and supplied in the listing are: front upper 80.5mm, front lower 114.8mm, rear upper 139mm and rear lower 135.5mm. The tie rod main diameter is increased to 6.5mm from the original 5mm to boost rigidity on scale crawling rigs.

Choose this stainless adjustable link set to replace tired plastic links or to fine tune toe and steering sensitivity on TRX4 trail crawlers.