TRAXXAS TRX4 Adjustable Front Brushguard Bumper Aluminum - TRX4330FE by GPM  [TRX4330FE]

Adjustable 6061-T6 Front Brushguard for Scale Crawlers

This TRX4330FE front brushguard bumper is an aftermarket aluminum upgrade made for scale trail crawler setups, providing adjustable height and approach angle so you can tune clearance and protection through tight lines. The design allows for accessory mounting, leaving room for a winch and lighting while minimising added mass to keep suspension handling consistent.

The kit is a 7pc assembly and ships with the required fasteners and D-rings for a straightforward fit. Main construction is aircraft-grade 6061-T6 aluminum to balance stiffness and weight. The centre rail gap adjusts between 42 and 44mm to accommodate a wider range of chassis mount patterns, and the integrated winch mount accepts the RC4WD single motor winch hole pattern Z-S1571 with a maximum mounting width of 74mm; winches larger than this width will not fit.

Installation notes: the bumper uses existing frame mounting points where possible, and height plus approach angle are set using the included hardware. The open front section preserves space for lights. Confirm winch compatibility before fitting, and keep track of the supplied stainless steel fasteners during assembly.

As a scale accessory this bumper focuses on modular protection and accessory mounting for trail rigs, with adjustability to refine approach angles and fitment across the stated platforms.