TRAXXAS T-Maxx / New E-maxx Alloy Front and Rear Lower Arms TMX2055W by GPM  [TMX2055W]

Alloy lower arms for TRAXXAS T-Maxx and E-maxx 2

This front and rear lower arm pair is a direct replacement for TRAXXAS T-Maxx 3.3, T-Maxx 2.5 and New E-maxx 2 chassis. Supplied as a single pair set, it comes with the associated hardware referenced in the product title to restore suspension geometry and track alignment after wear or impact.

Forged from alloy to reduce flex relative to stock plastic arms, these lower arms keep ride height and toe geometry while offering a firmer response under load. The set is suitable for hobby-level tuning where increased stiffness is wanted without changing shock valving or spring rates.

Fitting uses the original mounting points on the T-Maxx / E-maxx 2 suspension towers and steering blocks. Included pins, screws and e-clips mate with the factory retainers and preserve ball stud and bushing spacing, so only minimal setup is normally required after installation.

Choose these alloy lower arms when you need a direct-fit, tougher replacement for cracked or worn plastic arms to keep factory geometry and improve durability for hard off-road running.