TRAXXAS Tmaxx 3.3/Tmaxx 1.1 Aluminium Front Gearbox Brace TMX1012A by GPM  [TMX1012A]

Aluminium Front Gearbox Reinforcement

This aluminium front gear box brace is an RC-scale accessory made for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1. It replaces the stock front gearbox cover with a single-piece aluminium brace that increases rigidity while using the factory mounting points.

The part is supplied as a 1 pcs set and includes the screws required for installation. Fitting normally uses the existing bolt locations on the front gearbox and should not force chassis modification; verify alignment and clearances before final tightening.

As a setup item the brace adds stiffness to the front drivetrain to help preserve correct gear mesh under higher torque from aggressive motor and ESC combinations. Expect modest front-end handling changes and assess those during measured test runs and small setup adjustments.