TRAXXAS Tmaxx 3.3 / Tmaxx 1.1 Alloy Front Bulk Head Side Plate TMX1012 by GPM  [TMX1012]

Alloy front side plate for Tmaxx chassis

This alloy front bulk head side plate is an aftermarket replacement part made for TRAXXAS Tmaxx 3.3 and Tmaxx 1.1 models. It functions as the left and right side of the front bulk head assembly and is supplied with the mounting hardware listed in the product title. The part is intended for RC-scale use and installs into the vehicle's front chassis where the stock side plates are removed or upgraded.

Fit and role: the side plate locates the suspension mounting pins and links on the front bulk head, so it directly affects steering geometry and suspension pickup points. When swapping a damaged stock plate or upgrading to alloy for greater longevity, verify alignment of the suspension pins and check steering link clearance prior to final assembly.

Installation notes: remove the front body clip and any body mounts, support the front end to prevent gearbox or motor mount movement, then transfer original pins and spacers where applicable or use the supplied hardware. Tighten lock nuts to a firm setting without over-torquing; use the E-clips to retain pins as required. Cycle the suspension through full travel and recheck fasteners after the first run.

Choose this alloy side plate for a sturdy aftermarket replacement that maintains factory mounting points; always confirm supplied hardware and clearances during fitting.