TRAXXAS Telluride 4x4 Aluminium Main Shaft TEL025 - hardened ends by GPM  [TEL025]

Durable aluminium main shaft upgrade

This aluminium main shaft fitted with hardened steel end fittings is an aftermarket replacement for TRAXXAS Telluride 4x4 models. The design pairs a light aluminium shaft body with hardened steel terminations so wear concentrates where the shaft meets gears and bearings, making it useful for routine replacement or straightforward durability upgrades on off-road rigs.

The shaft ships as a single pcs unit and is made to fit the Telluride 4x4 platform as shown in the specifications below. Typical installation requires opening the gearbox or axle housing to remove the original shaft, swapping in the replacement, and checking gear mesh and bearing alignment. Minor spur and pinion spacing or bearing preload tweaks may be needed to keep the drivetrain running smoothly.

During fitment, ensure the steel end fittings seat correctly in the bearings and that axial play is within acceptable limits. After installation, run the vehicle briefly at low load to confirm smooth rotation before full use. Regular inspection of the hardened ends and adjacent bearings will spot wear early and help avoid secondary damage to gears.

Choose this shaft when replacing worn drivetrain pieces or when you want a simple durability upgrade for TRAXXAS Telluride 4x4 models; always verify fit and gear mesh during assembly.