TRAXXAS Slash Rear CVD Drive Shafts 304 Stainless + 6061-T6 Aluminum - SSLA1277RHA by GPM  [SSLA1277RHA]

Rear CVD replacement for TRAXXAS Slash platforms

This aftermarket rear CVD drive shaft set is made for TRAXXAS Slash chassis and sized for 1/10 drivetrain use. The design pairs stainless steel 304 axle joints with aluminum 6061-T6 shaft bodies to resist corrosion while keeping mass low for responsive handling.

Durability is a priority: the steel joints sit inside a protected axle arrangement to limit impact and debris exposure. Silicone O-rings at the joint interface reduce shock transfer on heavy landings, and the anodized 6061-T6 bodies are marginally thicker than stock to extend service life without compromising fitment.

Fitment notes: intended for rear gearbox-to-wheel installation on the listed Slash models. The kit includes 3mm steel hex shims for optional wheel-hex adjustment; verify wheel hex spacing and torque fasteners to your vehicle maker recommendations during installation. Intended for RC 1/10 scale use only.

Choose this set when you want a corrosion-resistant rear CVD that shields the joints and adds a slightly thicker shaft profile for longer service life; always confirm wheel hex and gearbox clearance before fitting.