TRAXXAS SLASH PRO 2WD Aluminum Rear Knuckle Arm Set SLA2W022 by GPM  [SLA2W022]

Aluminum rear knuckles built for short course racing

The SLA2W022 rear knuckle arm is an RC-scale replacement part produced for TRAXXAS SLASH PRO 2WD SHORT COURSE users seeking a stiffer, more precise rear linkage. Machined from aluminum 6061 T6, the arm resists flex under load compared with stock plastic pieces while POM shims are supplied to tighten the fit where the arm mates to the axle and tie rod mounting points.

Functionally this set stabilizes the rear arms and rear tie rods, and includes multi-position holes that let you change tie rod angles for tuning roll center and steering feel on short course setups. The package contains the hardware needed to swap the rear knuckle arm without modifying the chassis geometry.

Use these aluminum rear knuckle arms to reduce rear flex, improve drivetrain alignment, and fine tune tie rod angle for more consistent handling on short course tracks.