TRAXXAS Slash 4x4 Steering Turnbuckles SSLA160ST by GPM  [SSLA160ST]

Steering turnbuckles for Slash 4x4

This 3pcs set of spring steel turnbuckles with alloy ball ends is made for use on TRAXXAS Slash 4x4 1/10 scale models as a direct replacement or strength-focused upgrade for steering and suspension linkages. The spring steel shafts resist bending under load while the alloy ball ends preserve a stable ball-socket interface for reliable movement.

Fitting is straightforward: remove the worn linkage, note thread direction, then screw the new turnbuckle into the existing ball cup until you reach the required length and toe geometry. Because dimensions are model-specific, keep a record of factory reference settings and make small incremental adjustments to retain alignment and drivability.

In setup work, these turnbuckles deliver precise length control for toe and steering angle and provide a tougher connection that resists bending during impacts. Fit them when you need repeatable adjustments for handling balance or when replacing hardware that shows wear at the ball ends or threads.

A practical hop-up for maintaining steering geometry and front-end alignment on the Slash 4x4 chassis, supplied as a 3pcs set for selective replacement or targeted upgrades.