Traxxas Slash 4x4 Rear Widened CVD Drive Shaft with Knuckle Arm SSLA1277RH22 by GPM  [SSLA1277RH22]

Reinforced rear CVD assembly for Slash 4x4

This RC-scale rear CVD drive shaft assembly is made for Traxxas Slash platforms and is supplied as a 12pcs set. The design balances hardened steel parts with 6061 T6 aluminium to deliver strength where jumps and rough tracks demand it.

Key engineering points from the product data: the CVD uses hardened 45# steel mated to 6061 T6 aluminium, the knuckle arms are 6061 T6 aluminium, and the axle section is thickened to 6mm to better resist landing and high-speed impacts. A spring-steel hex stabilises the hex interface and quality bearings are fitted to keep rotation smooth under load.

Included component summary as supplied: CVD + hex ×2 pcs, rear knuckle arm ×2 pcs, bearing 6x13x5 ×4 pcs, screw pin M4x2.5x11 ×2 pcs, set screw 3x3 ×2 pcs, forming a complete rear assembly ready for fitment or rebuild tasks.

Use this assembly as a durability and handling upgrade in tuning: thicker axles and hardened materials lower the chance of flex or breakage from jumps and rough running, while aluminium knuckles reduce unsprung mass compared with all-steel options.

Choose this kit when you need stronger rear drive parts for aggressive short course use, and check your Slash variant for correct fit before installation.