TRAXXAS Slash 4x4 Polyurethane Ballends for SLA160LCG/BE by GPM  [SLA160LCG/BE]

Urethane ballends for SLA160LCG and SSLA160LCG

These aftermarket urethane ballends are supplied as a 12pcs set and act as direct replacement pieces for part numbers SLA160LCG and SSLA160LCG. The components are intended for RC linkage joints commonly used on TRAXXAS Slash 4x4 builds where those parts are fitted.

The ballends form the terminal joints on suspension and steering linkages and are a common wear item on models exposed to frequent setup changes or rough running. Polyurethane offers controlled flex compared with harder plastics, delivering a predictable linkage feel while resisting rapid deformation.

Installation follows the original linkage geometry: replace worn ballends one-for-one, confirm full thread engagement and secure against loosening, then check steering and suspension free play before running. Use this kit as routine spares to restore proper linkage function after extended service.