TRAXXAS SLASH 4X4 Low-CG Aluminium Main Shaft SLA025LCG by GPM  [SLA025LCG]

Low-CG aluminium drive shaft for Slash 4X4

This aftermarket main shaft is an RC-scale replacement part for the TRAXXAS SLASH 4X4 platform, supplied as a 1 pc set. The design pairs an aluminium shaft body with hardened steel end fittings to balance lower rotating mass with durable contact faces.

Fitment and installation are straightforward for hobbyists accustomed to Slash 4X4 driveline service: remove the original shaft from the gearbox or output assembly, check splines and bearings for wear, then refit the replacement shaft using the vehicle's original retaining hardware. Typical tools required are basic hex drivers and common bench supplies.

From a tuning perspective this low-CG shaft shifts rotating mass inward while the hardened steel ends protect spline and bearing interfaces, helping deliver smoother driveline response and longer intervals between service in off-road running and club-level setups.

This main shaft is intended as a direct replacement for Slash 4X4 drivetrains where reduced rotating mass and reinforced bearing interfaces are required; confirm spline profile and retaining hardware match before final installation.