TRAXXAS Slash 4x4 Front CVD Drive Shaft SSLA1280FHA by GPM  [SSLA1280FHA]

Front CVD shaft upgrade for Slash

The SSLA1280FHA front CVD drive shaft is an aftermarket replacement built for TRAXXAS Slash 1/10 4x4 platforms. It pairs stainless steel 304 axle joints with an aluminum 6061-T6 housing to balance corrosion resistance and reduced rotating mass in the front drivetrain.

Key construction points include stainless 304 joint cores to resist rust and a beefed-up shaft profile compared with the stock unit to extend wear life. The machined aluminum housing accepts the joint assembly and is offered in multiple finishes to match your rebuilds.

Silicone O-rings sit around the joint area to help absorb shock on landings and hard impacts, while the pivot components are located inside the shaft envelope to shield them from debris and direct strikes.

Included small hardware references cover 3mm steel hex shims, M4x2.5x11 and 3x3 screws, plus silicone O-rings, with the 3mm hex shim mentioned as optional depending on wheel hex tolerance.

Installation tips: replace one side at a time to maintain alignment, confirm spline engagement and wheel hex fit before final torque, and check for binding through full suspension travel after fitting to the front gearbox.

Choose this front CVD when you want a corrosion resistant joint and a stronger shaft profile for TRAXXAS Slash 4x4 rigs, keeping stock geometry while enhancing longevity and impact tolerance.