TRAXXAS Slash 4x4 Adjustable Turnbuckle Set SSLA160P by GPM  [SSLA160P]

Finished spring steel turnbuckles for Slash 4x4 setups

This 7pcs completed turnbuckle set is built for RC-scale use on TRAXXAS Slash 4x4 platforms and Telluride models. Each assembly features spring steel rod sections fitted with plastic ball ends and arrives ready to thread into existing linkage points.

These assemblies act as direct-fit replacements where the same ball end interface and general length are required, offering corrosion-resistant spring steel shafts with low-friction plastic ball ends. They suit steering and rear toe adjustments for hobbyists tuning suspension geometry on both track and rough terrain.

The kit ships as seven ready-to-install linkages, removing the need to assemble separate rods and ball ends; it speeds up replacing worn or bent turnbuckles without fabrication.

Fit these completed turnbuckles to recover steering precision and keep toe settings consistent, noting they are intended for Slash 4x4 and Telluride linkage assemblies only.