TRAXXAS Rustler VXL Alloy Front Arm Bulk RUS008 by GPM  [RUS008]

Front arm bulk in alloy for Rustler VXL

This aftermarket alloy front arm bulk is made for TRAXXAS 1/10 Rustler VXL models and fits as a direct replacement for the stock plastic parts. As a front suspension pivot component, the unit provides a firmer pivot point that influences steering geometry, toe stability and camber behaviour under load.

Fitting is straightforward for hobbyists comfortable with routine maintenance: remove the front suspension, swap the bulkheads, check alignment of pin and bearing seats and reassemble with thread locker where appropriate. No specialist tools are required beyond common hex drivers and standard spanners, though it is good practice to check fit and clearances on your chassis before final tightening.

From a tuning perspective, the alloy bulk reduces pivot flex to give a more predictable steering response when refining turn-in and mid-corner behaviour. Intended for RC tuning and repair work, this item should be used on 1/10 scale Rustler VXL models as specified.

Use the RUS008 alloy bulk to replace worn front bulkheads or to provide a firmer base for suspension setup adjustments on TRAXXAS Rustler VXL models.