TRAXXAS Rustler VXL Adjustable Stainless Tie Rods - RUS4160S by GPM  [RUS4160S]

Thick stainless tie rods for TRAXXAS handling upgrades

This 21pcs set is an RC steering and linkage upgrade made for TRAXXAS chassis, supplied as RUS4160S. The kit targets front and rear upper arm turnbuckles to stabilise steering geometry and add rigidity while keeping factory layout and mounting points unchanged.

The components use stainless steel hardware for improved corrosion resistance and dimensional stability. The thicker tie rod bodies resist bending better than thin-wall turnbuckles, and the counter-rotating threaded ends allow fine toe and steering trim during setup and tuning.

Contents: Tie Rod - 7 pcs, Stainless Steel Round Head Screws 3x16 - 10 pcs, Stainless Steel Flat Head Screws 3x16 - 2 pcs, Stainless Steel Round Head Screws 3x12 - 2 pcs. These items are for model-level assembly and replace OEM link parts where thread pitch and length match the original fittings.

Fitting advice: check thread pitch and rod-end width before fitting, apply thread-locker where your build requires it, and recheck toe after installation to ensure balanced steering. The adjustable turnbuckles are suitable for fine camber and toe setup when combined with standard ball ends.

Choose these stainless tie rods when you want a direct-fit, adjustable replacement to stiffen steering linkage and sharpen handling on the listed 1/10 TRAXXAS models.