TRAXXAS Rustler 4X4 VXL Rear Stub Axle Carriers - 7075 Alloy Upgrade RUS4022N by GPM  [RUS4022N]

7075 Alloy Rear Stub Axle Housings

This aluminium rear stub axle carrier set is an aftermarket replacement for selected TRAXXAS 1/10 4x4 platforms. The parts are machined from 7075 alloy to balance low mass with higher tensile strength, while the carrier geometry targets improved stability where the rear lower and upper arms meet the axle interface.

Bearings sized 5x13x4 are located in a tighter seat to cut axial and radial play. Narrower clearance at the bearing helps the rear wheel joints run truer, yielding more consistent rotation under acceleration, cornering and changing loads.

Installation notes: these carriers are direct-replacement items for the listed TRAXXAS models and will reuse original fasteners and bearings where applicable. During reassembly check bearing orientation, set appropriate preload, and confirm driveshaft and linkage clearance before final torque.

Fit these carriers to restore tighter bearing alignment and reduce rear-end play on compatible TRAXXAS 1/10 4x4 models; they are a simple aluminium upgrade when replacing worn plastic housings.