TRAXXAS Revo Throttle & Brake Alloy Upgrade with Delrin Bearings - TRV1325 by GPM  [TRV1325]

Alloy throttle and brake upgrade for Revo platforms

This aftermarket throttle and brake linkage set is made for TRAXXAS Revo and Revo 3.3 models. The TRV1325 replaces fragile plastic levers with an alloy assembly that uses Delrin bearings to cut pivot friction while keeping the standard Revo throttle and brake layout intact.

The unit works as a direct replacement for the stock lever assembly, delivering a firmer mounting surface and low-friction Delrin bushings at the pivot points. It is intended for tuning throttle and brake response and for hobbyist maintenance where plastic pivot wear is a concern.

Installation is straightforward for technicians familiar with Revo mechanical layouts: remove the stock lever, transfer any needed linkages and fasteners, and fit the alloy assembly into the original mounting location. Typical setup checks include confirming smooth travel through the full range, verifying clearance at full throw, and adjusting linkage length or servo centring as required.

As an aftermarket accessory, confirm fitment on your chassis and reuse original mounting hardware where appropriate. Inspect Delrin bearings and fasteners after initial runs to ensure secure fit and consistent operation.