TRAXXAS Revo Front Upper Arm Alloy Sandwich - TRV054RS by GPM  [TRV054RS]

Right-side alloy front upper arm for TRAXXAS Revo

This replacement front upper arm is made for TRAXXAS Revo and Revo 3.3 platforms and is supplied as a single right-side piece. The alloy sandwich construction and included mounting screws and pins let you swap the part into compatible Revo suspension setups with minimal prep.

The arm functions as a direct substitute for the factory right-side upper link, restoring intended suspension geometry while offering greater stiffness than stock plastic parts. Increased rigidity helps keep knuckle and shock mount points aligned under load, making handling and trim work more predictable on varied surfaces.

Installation notes: fit the arm using the supplied pins and hex screws, check pin diameter and hole alignment before final assembly, use the correct hex driver to tighten hardware evenly, and verify steering linkage and shock end clearance after fitting. Always test-fit and re-torque fasteners after the first running session.