TRAXXAS E Revo Front and Rear Steel #45 Steering Pillow Balls ER007S by GPM  [ER007S]

Steel #45 pillow balls for TRAXXAS E Revo steering pivots

This aftermarket kit supplies four Steel #45 pillow balls designed for use on TRAXXAS E Revo platforms and the compatible models shown below. These parts are speced as Steel #45 and serve as direct-fit replacements for front and rear steering pivot locations on RTR-scale vehicles.

Fitting is straightforward for those experienced with steering linkages: remove the original pillow balls from the steering knuckles and tie-rod ends, inspect mating hardware for wear, then fit the steel pillow balls into the knuckles and link ends using the original screws or retained hardware. No chassis modification is required on compatible models.

From a setup perspective, steel pillow balls improve pivot durability and can produce a firmer steering feel compared with softer materials; they are often chosen where heavy use or impacts accelerate wear on stock components. After installation verify free movement and re-torque fasteners to recommended settings before running.

Use this 4pcs set for maintenance or upgrade work on the listed TRAXXAS models to restore steering geometry and extend pivot life; check fit on your first test run.