Traxxas Revo Damper Pair Titanium - RE-003/T by 3Racing  [RE-003/T]

Traxxas Revo Extreme Damper ( 1 Pairs ) - Titanium Color - 3RACING RE-003/T
Price:
CAD$0.00
Brand:
3Racing
Model:
RE-003/T
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Revo-compatible titanium damper summary

The RE-003/T damper set is an aftermarket replacement for Traxxas Revo models, supplied as a matched pair in a titanium colour finish and intended for model-scale suspension use.

Functionally these shocks serve as direct-replacement dampers for maintenance or tuning, letting you restore damping behaviour, change ride response, and try different setups without modifying chassis geometry. The pair fits where the original damper form factor matches Revo shock towers and mounting points.

Installation follows standard RC shock steps: remove wheel and body as required, relieve spring preload, unfasten top and bottom mounts, swap the dampers into the same positions, and reassemble. After fitting, verify mounting hardware torque, confirm free piston travel, and perform a short low-speed check to ensure correct operation before high-speed runs.

Tuning role - these dampers are made to accept different oils and springs so owners can refine compression and rebound during setup work. Use safe handling procedures when changing shock oil or working with small tools.

A practical Revo-compatible damper pair in a titanium colour finish focused on replacement and tuning tasks for Traxxas Revo users.

They are designed to match common Revo shock lengths and mount patterns; measure your vehicle's shock length and mounting spacing to confirm compatibility before ordering.
The package contains one matched pair of dampers as described in the product title. Springs or additional hardware are not included unless stated separately.
No special tools are required beyond typical RC maintenance gear such as hex drivers, pliers, and spring compressors. Basic hand tools are sufficient for fitting.
Yes, they are intended to be used with varied shock oil weights and springs to refine rebound and compression for fine-tuning handling.

Copyright © 2008-2026 rcjaz.ca All rights reserved