TRAXXAS Revo Centre Gearbox Skid Guard Alloy - TRV014X by GPM  [TRV014X]

Centre gearbox protector for Revo

This aftermarket skid guard fits the TRAXXAS Revo and Revo 3.3 platforms and serves as a durable protective plate for the centre gearbox area of the model-scale vehicle. Made from alloy, it replaces the stock lower protection and redirects impacts away from the gearbox casing during hard landings, rough surfaces, and rock crawling sessions on scale tracks.

Fitment and role: the part is produced specifically for TRAXXAS Revo /Revo 3.3 layouts and mounts to the chassis in the centre gearbox zone, providing a rigid barrier that helps reduce direct blows to the gearbox shell. As a hop-up, it contributes to chassis longevity and streamlines repair work by preventing crush damage to internal gear housings.

Installation notes: the item is supplied as a single set with mounting screws included, designed to use the existing chassis mounting points. Basic disassembly of the lower chassis plate may be required to access fastener locations, and a correct hex driver should be used to avoid stripping screws. Check fastener torque after initial runs and re-tighten as needed to compensate for material settling.

Tuning and maintenance: while the alloy guard increases protection, it can slightly change the centre of mass distribution depending on overall setup; consider this when fine-tuning suspension damping and ride height. Inspect the plate and mounting screws regularly after heavy use and replace damaged screws with equivalent grade hardware to maintain secure attachment.