TRAXXAS Revo Alloy Engine Mount with Heat Sink TRV080 by GPM  [TRV080]

Machined alloy mount for TRAXXAS Revo

The TRV080 is an aftermarket alloy engine mount created for TRAXXAS Revo and Revo 3.3 platforms. As a direct replacement it locates the nitro engine at the chassis' stock mounting points while adding a machined heat sink surface to help dissipate head temperature during runs.

This mount performs two core tasks: provide a rigid, repeatable interface between engine and chassis for consistent power delivery, and increase the contact area for passive cooling where the engine head meets the mount. The alloy construction reduces flex versus many plastic mounts, which can help retain ignition and idling behaviour under load.

Fitting is a mechanical swap that keeps the factory Revo mounting pattern. When installing, check engine stud alignment and chassis hole spacing before final torque, use the correct hex driver and progressive tightening to avoid thread damage, and confirm clearance to adjacent parts and airflow paths after assembly.