TRAXXAS MAXX Widen Track Front and Rear Arms with Adjustable CVD Kit TXMS100N by GPM  [TXMS100N]

Widening arm and CVD reinforcement kit

This GPM TXMS100N kit is an RC-scale widening and reinforcement package made for TRAXXAS 1/10 4WD MAXX monster trucks. It includes matched front and rear upper and lower arms, adjustable CVD drive shafts, aluminum hex adapters and wheel locks, plus a stainless steel adjustable front tie rod to broaden the track and refine suspension geometry. The design moves the wheel track outward by 20mm per side to boost lateral stability while maintaining driveline integrity through upgraded CVD joints and stronger axles.

Key build details from the kit: primary aluminum parts are machined from 6061 T6 for a balance of light weight and tensile strength, delrin collars and 4mm delrin shims are supplied to close fitment gaps, the assembly uses pins with small retaining screws to reduce thread wear, and multiple damper mounting points allow suspension angle tuning. Hardened steel joint inserts work with alloy bodies, and axle diameter is increased from 6mm to 8mm to tolerate higher loads. The accessory pack also supplies bearings matched to the larger axles.

For builders wanting a wider stance on a TRAXXAS MAXX chassis, the TXMS100N delivers aluminium arms, beefed-up CVDs and a full hardware set to raise lateral control while allowing suspension geometry adjustments.