This 8 piece RC aluminium wheel hub hex is made for TRAXXAS MAXX applications and extends wheel offset by +10mm to alter track width and wheel placement without changing axle geometry.
The design works with common CVD-to-wheel interfaces to transmit drive from the driveshaft to the wheel while keeping centring and rotational alignment. The original accessory notes list stainless steel fasteners and shims to secure the hubs and fine-tune clearances.
Fit these hexes when you need extra clearance for wider tyres or custom beadlock wheels, or when fitting wheels with a different offset during chassis setup. Installation requires standard hex drivers and a final spin check with your chosen wheel and tyre combo.
8956
A straightforward aftermarket hex set aimed at offset adjustment and secure mounting; always confirm wheel fitment and torque on the stainless fasteners during installation.
Copyright © 2008-2026 rcjaz.ca All rights reserved