TRAXXAS MAXX Servo Mount and Linkage Aluminum Upgrade TXMS024A by GPM  [TXMS024A]

Stiffer aluminum servo mount and steering linkage for TRAXXAS MAXX

This aftermarket assembly replaces the stock servo mounting on TRAXXAS MAXX 1/10 Monster Truck platforms to accept larger-format servos using the same mounting footprint as 2075x-style units. The kit concentrates on the steering system by repositioning and securing the servo, supplying an aluminum tie rod, and including a 25T aluminum servo horn to retain accurate linkage geometry under load.

Installation follows a direct-replacement approach for the specified MAXX chassis, using the supplied fasteners and shims to set servo height and horn position. The aluminum parts yield a firmer mounting point versus molded components, reducing servo-interface flex and making steering inputs more consistent when you adjust end-point or steering rate.

For tuning, this kit helps when upgrading to a heavier, higher-torque servo: it keeps horn offset and tie rod alignment correct so steering trim and dual-rate changes respond predictably, and it simplifies maintaining Ackermann and toe while testing different horn and centring setups.

Builders switching to a stronger servo or wanting a firmer servo-to-chassis interface on the TRAXXAS MAXX will find this aluminum mount and linkage set makes steering geometry more repeatable during setup and testing.