TRAXXAS MAXX Rear Chassis Link Protector 6061-T6 - TXMS016R by GPM  [TXMS016R]

Rear link guard and reinforcement

This aluminum rear chassis link protector is an RC-scale upgrade intended to reinforce and shield the rear linkage area on Traxxas MAXX models. The unit shown is machined from 6061-T6 aluminum to provide a balance of light weight and tensile strength, and it arrives with the mounting hardware needed for installation.

Included in the kit are: Protector - 1 pcs, Stainless steel round head screw 4x30 - 2 pcs. The protector sits over the rear chassis link to reduce direct impact and abrasion from debris or contact during aggressive off-road runs.

Installation is straightforward for a model builder with basic tools: remove the stock link guard or clear the mounting points, align the protector with the rear link area, and secure using the supplied screws. No additional components are required, but check thread fit and use correct screw engagement to avoid stripping in composite frames.

Tuning role: the protector is a structural add-on rather than a suspension tuning part; it helps protect link geometry and fasteners from impact, which can reduce unplanned changes to suspension behavior after hits. It can be part of a durability-focused setup for trail or bashing sessions.

Fit this protector when rear link breakage or wear is a recurring issue, and routinely check surrounding fasteners after heavy runs to keep suspension geometry consistent.